Bayliner 1950 1952 1954 2150 2152, Дополнение к руководству пользователя

Страница: 28 / 56

CHAPTER 6: PLUMBING Classic Runabouts • Owner’s Manual Supplement
22
Bilge Pump Testing
•
The bilge pump is critical to the safety of your boat.
•
Check the bilge pump often to make sure it is working.
Test the pump as follows:
1. Turn on the bilge pump switch at the helm.
2. Any water in the bilge should pump overboard.
•
If the pump motor is running, but not pumping, inspect the discharge hose for a kink or collapsed area.
•
If no problems are found, check the bilge pump housing for clogging debris as follows:
1. Remove the power cartridge:
a. Lift the tab while rotating
the fins counter-clockwise.
b. Lift out the power cartridge.
c. Clear the outer housing
of debris.
2. Reinstall the power cartridge:
a. Make sure the “O” ring is
properly seated.
b. Coat the “O” ring with a
light film of vegetable or
mineral oil.
c. Align the cams on either
side of the power cartridge
with the two slots on the
outer housing
d. Press the power cartridge
into the housing while twisting clockwise
3. Check the reinstallation by trying to twist the fins counter-clockwise without lifting the tab; the cartridge should
stay in place.
OF OIL “O” RING
TAB FIN
POWER
CARTRIDGE
SLOT CAM
(TYPICAL)
LIGHT FILM
BILGE PUMP COMPONENTS
OUTER
HOUSING
(TYPICAL)