Bayer HealthCare BR4224, Инструкция по эксплуатации

Страница: 9 / 44

9 EN
• Take the power plug and unwind the power cord to the
required length, connect the power plug to the mains
socket.
• The yellow mark on the power cord indicates the
maximum cord length. Do not pull out the power cord
further than the red mark.
• Press the on/off button (20) to switch the vacuum
cleaner on.
• While cleaning, you can control the suction power
using the manual suction power control (6) on the
flexible hose handle (5) and with the suction power
control buttons «+/-», the digits «1-2-3-4-5» on the
display (17) will show the suction power level, the
optimum suction power ratio and the surface type for
cleaning will be shown with the symbols in the upper
line of the display (17) (pic. 1).
• After you finish cleaning, switch the vacuum cleaner off
by pressing the on/off button (20) and unplug it.
• To wind the power cord, press the button (18); keep a
hold of the winding cord with your hand.
• If you have to make a break during the cleaning,
switch the vacuum cleaner off by pressing the button
(20) and install the brush (1) to the brush storage (19)
(pic. 3).
ATTENTION!
Before changing the attachments or cleaning the
dust bin (15), switch the vacuum cleaner off by
pressing the on/off button (20) and unplug it.
CLEANING AND MAINTENANCE
Cleaning the dustbag (15)
• If during cleaning the dustbag-full symbol appears
on the display (17) (pic. 2), clean the dustbag (15) or
replace the disposable paper dustbag (26).
Note: the paper dustbag (26) is disposable, when the
dustbag (26) is full, dispose of it.
• Before cleaning the dustbag (15), switch the vacuum
cleaner off by pressing the on/off button (20) and unplug
it.
• Open the dustbag compartment lid (13) by pressing the
lid lock (12).
• Remove the dustbag holder (14) with the dustbag (15).
• Take the dustbag (15) out from the holder (14).
• Place the dustbag (15) above the garbage bin, remove
the plastic clamp and clean the dustbag (15) of garbage
and dust. You can wash the dustbag (15) with warm
water and soft detergent, rinse and dry thoroughly. After
that install the plastic clamp on the dustbag (15).
• Install the dustbag (15) into the holder (14).
• Put the dustbag holder (14) with the dustbag (15)
installed into the dustbag compartment body.
• Close the dustbag compartment lid (13) and slightly
press on the lid (13) until the lock (12) clicks.
Notes:
– do not try to close the lid (13) without the dustbag holder
(14) installed, otherwise you can damage the lock or the
lid (13);