Bayby BBM 7010, Руководство пользователя

Страница: 12 / 20

Digital Audio Baby Monitor EN
12
Attention:
For safety reasons, the parent unit A
1
when powered from an external power source can only be put
into operation with rechargeable batteries inserted inside.
■
Internal power source and its use
– For powering the parent unit from an internal power source, use the supplied Ni-MH type AAA
batteries (2× 1.2 V / 400 mAh).
– From the rear of the parent unit A
1
, remove the cover of the battery compartment C
9
. Insert
rechargeable batteries into this compartment C
9
. When inserting the batteries, make sure that
you maintain the correct polarity, which is marked in the battery compartment C
9
. Close the cover.
– The rechargeable batteries must be charged for at least 16 hours before the parent unit A
1
can be
used for the fi rst time independently of the external power source. The batteries will start charging
when the parent unit A
1
is connected to an external power source. The number of segments in
the symbol D
5
cyclically increases and decreases thereby signalling that the batteries are being
charged. The number of permanently lit segments in symbol D
5
corresponds to the battery power
level. You may use the parent unit A
1
while it is charging.
Note:
Subsequent recharging will require only approximately 10 hours.
– When the batteries are fully charged, the symbol D
5
will show all the segments . When you
disconnect the parent unit A
1
from the power socket after charging it, you may use it independently
of an external power source.
– Fully charged batteries will provide approximately 10 hours of operation. The operating time depends
on the power level of the batteries, their capacity, operating mode of the parent unit, etc. The
maximum battery capacity is achieved after they have been fully charged several times. The lifetime
of the batteries depends on many factors such as recharging frequency, ambient temperature at
which the batteries are charged and stored, etc.
– We recommend that the batteries are charged and kept at room temperature and at least once
every six months to allow them to fully discharge in the parent unit A
1
and subsequently recharge
them fully.
– Battery operation minimises electro-smog which arises due to the effect of alternating electric and
magnetic fi elds.