Bay Networks 8000 RAC, Инструкция по установке

Страница: 71 / 148

2-27
Chapter 2 Installing the Model 8000 Remote Access Concentrator
Installing the Model 8000 Remote Access Concentrator
Self-Booting the Remote Access Concentrator
The RAC comes equipped with Flash memory that contains an
operational image you can use to self-boot the unit. To self-boot your
RAC:
1. Initialize the IP address parameters using the manual
initialize method.
The manual initialization method is described in Manually
Initializing the IP Address Parameters on page 2-22 .
2. Enter the sequence command at the monitor prompt.
The following prompt is displayed:
Enter interface sequence [net]::
3. Enter self, net as the sequence.
The monitor prompt is displayed.
4. Enter the boot command at the monitor prompt.
The display looks similar to this:
monitor:: boot
Requesting default boot file “OPER_64_ENET.SYS” for
MOP/VMS\ loads and “oper.64.enet” for all other
protocols. Unanswered requests shown as ‘?’,
transmission errors as ‘*’.
Booting file: “OPER_64_ENET.SYS” from SELF
Loading image from SELF ...
.................................................
Load Completed
The self-boot takes 10 seconds to complete. After the RAC
boots, Monitor mode is no longer active.