Baxi LUNA HT 1.350, Инструкция по эксплуатации, Страница: 76 / 104

76
instructions pertaining to the user 924.493.3
it
at
gB
3.5.2
setting the daily times for domestic hot water mode operation
- As supplied by the factory the appliance is set up with the domestic hot water function always enabled and the domestic
hot water programming function disabled.
The instructions for enabling this program are given in chapter 15 , which is addressed specifically to installers (parameter
H91).
If the program is enabled program lines from 31 to 36 must be set up as described in heading 3-5.1.
3.6 setting the minimum central heating temperature
- press either of the keys to access the programming function;
- press these keys until the display shows
p5
, referring to the temperature to be set;
- press the keys to set the temperature required.
This operating mode is enabled when minimum temperature central heating mode “ ” is activated or when the daily central
heating program does not require heat.
N.b – With the outdoor sensor probe connected, parameter p5 can be used to set the minimum room temperature
in the premises to be heated.
3.7 table of user-settable parameters
range
0…23:59
25..80
00:00…24:00
00:00…24:00
00:00…24:00
00:00…24:00
00:00…24:00
00:00…24:00
00:00…24:00
00:00…24:00
00:00…24:00
00:00…24:00
00:00…24:00
00:00…24:00
0...1
Factory
setting
———-
25
6:00
22:00
0:00
0:00
0:00
0:00
0:00
24:00
0:00
0:00
0:00
0:00
0
parameter description
Time of day setting
Minimum central heating temperature setting (°C)
Start of first daily period of automatic central heating
End of first daily period of automatic central heating
Start of second daily period of automatic central heating
End of second daily period of automatic central heating
Start of third daily period of automatic heating
End of third daily period of automatic central heating
Start of first daily period of domestic hot water production (*)
End of first daily period of domestic hot water production (*)
Start of second daily period of domestic hot water production (*)
End of second daily period of domestic hot water production (*)
Start of third daily period of domestic hot water production (*)
Fine End of third daily period of domestic hot water production (*)
Reset of daily central heating and domestic hot water production programs (factory
settings). Press the - + keys together for about 3 seconds; the number 1 appears
on the display. Confirm by pressing either of the keys
Note: Parameters from p31 to p36 can be displayed only if the domestic hot water program has been enabled as described
in chapter 15 for the attention of the installer (parameter H91).
parameter
n.
p1
p5
p11
p12
p13
p14
p15
p16
p31
p32
p33
p34
p35
p36
p45