Baxi LUNA DUO-TEC MP 1.110, Инструкция для пользователей и установщиков

Страница: 37 / 96

37
INST
ALLER Section (en)
7115213.01 (4-10/14)
TABLE 2
PARAMETERS - rpm
VENTURI
Ø (mm)
GAS NOZZLES
Ø (mm)
CO
2
Min
(%)
CO
2
Max
(%)
Max. CO
(ppm)
P60** P30 – P61** P59**
Boiler
model
Min. power Max. power Ignition power
G20 G31 G20 G31 G20 G31 G20- G31 G20 G31 G20 G31 G20 G31 G20/G31
1.90 1250 1500 6500 6200 2400 2400 34
Qƒ Qƒ
*8,5 *9,9 *9,0 *10
< 250
1.110 1300 1300 6900 6700 2500 3000 38
Qƒ Qƒ
*9,0 *9,5 *9,2 *10
*
CO
2
with cover closed. Without cover (chamber open) the value is less than
** value read on the boiler front panel display to multiply x 10 (e.g.: 150 corresponds to 1500 rpm)
7RVLPSOLI\FDOLEUDWLRQRIWKHJDVYDOYHVHWWKH³FDOLEUDWLRQIXQFWLRQ´GLUHFWO\RQWKHERLOHUFRQWUROSDQHODVGHVFULEHGLQ
section 12.2.
)RUFDVFDGHGXFWVFKDQJHWKHSDUDPHWHU3LQFUHDVLQJWKHQXPEHURIIDQUHYROXWLRQVE\VHHWDEOH%LQFKDSWHU
16. ADJUSTMENT AND SAFETY DEVICES
The boiler has been designed in full compliance with European reference standards and in particular is equipped with the following:
‡
Limit thermostat
7KDQNVWRDVHQVRUSODFHGRQWKH&+ÀRZOLQHWKLVWKHUPRVWDWLQWHUUXSWVWKHÀRZRIJDVWRWKHEXUQHULIWKHZDWHULQWKHSULPDU\
circuit overheats. Under such conditions the boiler is blocked and only after the fault has been eliminated can it be ignited again
by pressing
.
‡ ([FKDQJHUÀDQJHWKHUPRVWDWƒ&
7KLV GHYLFH LV ORFDWHG RQ WKH H[FKDQJHU ÀDQJH DQG LQWHUUXSWV WKH ÀRZ RI JDV WR WKH EXUQHU LI WKH IURQW LQVXODWLRQ \LHOGV DQG
RYHUKHDWVWKHH[FKDQJHURUWKHÀDQJHJDVNHWGHYHORSVDIDXOW3UHVVWKHUHVHWEXWWRQRQWKHWKHUPRVWDWHOLPLQDWHWKHIDXOWDQG
then press the reset button on the boiler control panel.
‡
Thermal fuse
7KLVGHYLFHLVORFDWHGDWWKHUHDURIWKHH[FKDQJHUDQGLQWHUUXSWVWKHÀRZRIJDVWRWKHEXUQHULIWKHUHDULQVXODWLRQ\LHOGVDQG
overheats the exchanger. If this device cuts in, dismount the exchanger and replace the thermal fuse (see paragraph “THERMAL
FUSE REPLACEMENT OF HEAT EXCHANGER”).
It is forbidden to disable this safety device.
‡ 17&ÀXHVHQVRU
7KLVGHYLFHLVSRVLWLRQHGRQWKHIXPHVGXFW7KHHOHFWURQLFERDUGVWRSVJDVIURPÀRZLQJWRWKHEXUQHULQFDVHRIRYHUKHDWLQJ
Press to re-establish normal operating conditions.
7KHDERYHUHVHWRSHUDWLRQLVRQO\SRVVLEOHLIWKHWHPSHUDWXUHLVOHVVWKDQƒ&
It is forbidden to disable this safety device
‡
Flame ionisation detector
7KHÀDPHVHQVLQJHOHFWURGHJXDUDQWHHVVDIHW\RIRSHUDWLRQLQFDVHRIJDVIDLOXUHRULQFRPSOHWHLJQLWLRQRIWKHPDLQEXUQHU,Q
these conditions, the boiler blocks. Press to re-establish normal operating conditions.
‡ +\GUDXOLFSUHVVXUHVZLWFK
This device allows the main burner to be ignited only if system pressure is higher than 0.5 bars.
‡
Pump post-circulation
The electronically-controlled pump post-circulation function lasts 3 minutes and is enabled, in the heating mode, if the ambient
thermostat causes the main burner to go out.
‡ $QWLIUHH]HGHYLFH
7KHHOHFWURQLFERLOHUPDQDJHPHQWV\VWHPLQFOXGHVDQ³DQWLIUHH]H´IXQFWLRQIRUWKHKHDWLQJDQG'+:V\VWHPVZKLFKZKHQÀRZ
WHPSHUDWXUHIDOOVEHORZƒ&RSHUDWHVWKHEXUQHUXQWLODÀRZWHPSHUDWXUHRIƒ&LVUHDFKHG7KLVIXQFWLRQLVHQDEOHGZKHQWKH
boiler is switched on, the gas supply is open and the system is correctly pressurised.