19
9.0
Fitting the Trim & Fender – Page 19
9.1 Fitting the Trim and Fender
1. Carefully remove the trim and fender from their
packaging. Place trim on its back to prevent falling over.
9.2 Wentworth Models
(Fig. 31)
1. Align the trim with the fire outer frame. The trim has four
keyholes type cutouts on the inside edge which locate on
the keyways of the black side trims.
2. Place the fender assembly centrally between the legs of
the trim and carefully push it back as far as possible.
3. In a similar manner place the controls access door
centrally in the fender opening and push back as far as
possible.
9.3 Kingston 2 Models
(Fig. 32)
1. Take the outercase location bracket from the kit and
fasten it using the existing 2 screws to the canopy (Fig.
32). This will now mate with the bracket on the back of the
trim.
2. Align the brackets on the rear of the trim assembly with
those on the fire outer frame, and lower the trim into
position.
3. Place the fender assembly centrally between the legs of
the trim and push it back as far as possible.
4. Place the controls access door centrally in the fender
opening and push back as far as possible.
9.4 Informing the User
1. These instructions and the users instructions should be
handed to the customer. At the same time the customer
should be shown how to operate the fire safely and
efficiently.
2. The need for annual servicing should be emphasised
and the returning of the guarantee card advised.
