13
5.0
Installation – Page 13
5.2 Fitting the Fire (cont)
8. Engage the tensioning nuts on the threaded shanks of
the tensioning devices. Run the nuts down to the
hexagonal heads of the tensioning devices (Fig. 16).
9. From the front insert the cable tensioning devices
through the combustion box rear panel. The hexagonal
heads must be to the inside of the box (Fig. 16).
10. Position the appliance in front of the fireplace opening
and insert the cables in the holes in the combustion box
rear flange (Fig.17). Pass the cables through the eyebolts
in the builders opening rear face and insert them in the
tensioning devices (Fig. 16 & 17). Where the electrical
supply is being routed through the rear panel, pass the
cable through the hole at the right hand side. Do not draw
any more cable into the fire than is necessary. Manoeuvre
the appliance backwards into the opening, drawing any
slack length of cable through the tensioners.
11. Push the appliance as far back in the opening as
possible and pull the cables through the tensioners as tight
as possible.
12. Run the solderless nipples down the cables to the
tensioners and tighten their securing screws (Fig. 16). As
required, take the relevant grommet(s) and slide over the
gas and/or electrical supplies. Run the grommet(s) down
the pipe and/or cable and insert in the hole in the rear
panel.
13. Using a suitable spanner tighten the tensioning nuts
clockwise so that the fire frame surround is pulled up
against the wall or surround and the seal is compressed.
DO NOT CUT OFF THE EXCESS CABLE
- coil neatly and
secure with tape.
14. Fit the inlet elbow supplied in the kit to the controls
feed pipe. Refit the burner chassis, taking care not to catch
the motor drive cable in the fire and connect the gas
supply to the inlet elbow (Fig. 18 & 19). The screws which
secure the bulb housing are transit screws only, these
should be removed (Fig. 18).
15. The side and rear brick effect insulation panels can be
reversed to offer a plain effect for the customer. To reverse
this brick effect remove the black sheet metal retaining
panels left and right hand side. Carefully remove the three
insulation panels and reassemble with the plain effect on
display. Refit the retaining panels taking care not to
damage the paint and insulation panels.
