To turn the fire off.
Slide the button up past the high heat position to the "O" position.
Both the main burner and the pilot should go out.
While cooling, the coals may make some crackling
noises. This is quite normal.
Lighting with a taper.
(See figure 3).
In the unlikely event of failure of the ignition
spark, the pilot can be lit by a taper or long spill.
Insert the taper or spill through the lower left hand
opening in the front of the fuel effect bed and
operate the slide control as described previously.
CLEANING YOUR FIRE
To maintain the high performance and quality finish of your appliance, please follow
these guidelines:
!
Before attempting to clean the fire, please remember to turn off the fire and wait for
the appliance to cool. The fire will retain heat for some time before cleaning can begin.
!
If any pieces of debris are found in the firebox, have the chimney inspected before
further use.
Metal parts
!
Clean the metal parts with a slightly damp cloth and then dry.
!
Do not use abrasive cleaners as these will scratch the fire surface.
Ceramic fuel effect and rear wall.
!
This product uses fuel effect pieces and burner compartment rear wall
containing Refractory Ceramic Fibres (RCF), which are man-made vitreous
silicate fibres. Excessive exposure to this material may cause irritation to eyes, skin
and respiratory tract. Consequently, it is important to take care when handling
these articles to ensure that the release of dust is kept to a minimum.
!
Light coatings of soot will usually be burnt off during the normal operation of the
fire.
!
Should any soot accumulation become excessive, the fuel effect pieces and walls
should be removed from the fire for cleaning.
!
Cleaning should be carried out in a well ventilated area or in the open air by gently
brushing with the pieces held away from your face so that you avoid inhaling the dust.
!
We suggest that you remove the coals in the reverse order to that shown in the fuel
Page 8
OWNER GUIDE
Figure 3. Lighting with a taper
