bed refitting instructions.
Burner.
!
The burner surface can be carefully cleaned to remove any loose particles after
taking off the coals. Make sure that no particles are pushed into the burner holes.
FUEL BED REFITTING
The position of the fuel bed ceramic pieces is important. Do not alter the position of
the fuel bed ceramic pieces from that shown in this section of the owner guide.
1.
Place the rear base coal in the firebox.
It should rest on the ledges at the rear
sides of the burner unit. When located
gently move the rear base coal so that it is
as far forward as possible. The amount of
movement will be negligible (See figure
4).
2.
Place the front base coal in the firebox
with its bottom front locating over the
front rim of the firebox. Pull the coal
forward so that it locates immediately
behind the front rim of the firebox. (See
figure 5).The front base coal will touch
the rear base coal as it is located.
There are two types of loose coals. These are
identified with the letter “A” or “B” on the
underside of the coal.
There are three “A” coals and two “B” coals.
Page 9
OWNER GUIDE
Figure 4. Rear Base Coal Position
Figure 5. Front base
coal position
