!
The control control knob can then be set to your preferred heat level. The settings
are: -
To turn off
partially depress the knob and turn clockwise to off.
Wait at least three
minutes before attempting to relight.
Lighting with a match or taper.
Manual ignition:
Depress the control knob and turn anticlockwise towards the 1/IGN
position.
Electronic ignition:
Depress the control knob slightly and turn anticlockwise towards
the 1/IGN position.
While keeping the knob depressed, light the pilot by inserting a long match or taper into
the opening shown in figure 3 (Second opening from the right).
When the pilot is alight, keep the knob depressed for about ten seconds to allow the
flame sensing probe to warm up before setting to your preferred heat level.
For your own convenience, have the heater serviced as soon as possible.
CLEANING YOUR FIRE
Turn the fire off and allow it to cool before attempting any cleaning.
Normally the fire will only need dusting. The bright metal trims may be cleaned with a
damp cloth and dried with a soft duster. Obstinate marks can be removed from the guard
and trims using soapy water.
Never use abrasive cleaners.
The radiants can be cleaned with a soft brush - see below for how to remove the
radiants.
Page 9
OWNER GUIDE
©
Baxi Heating U.K. Limited 2006.
Control Knob
Position
Radiants Condition
2
Centre radiants on low. Outer radiants off.
(The right hand centre radiant will glow slightly
more than than the left hand centre radiant due
to the pilot flame)
3
Centre radiants fully on. Outer radiants off.
4
Centre radiants fully on. Outer radiants on low.
5
All radiants fully on.
