page 3
IMPORTANT - Installation, Commissioning,
Service & Repair
This appliance must be installed in accordance with
the manufacturer’s instructions and the regulations
in force. Read the instructions fully before installing
or using the appliance.
In GB, this must be carried out by a competent
person as stated in the Gas Safety (Installation &
Use) Regulations.
Definition of competence: A person who works for a
CORGI registered company and holding current
certificates in the relevant ACS modules, or valid
ACoP equivalents, is deemed competent.
In IE, this must be carried out by a competent
person as stated in I.S. 813 “Domestic Gas
Installations”.
Codes of Practice,
most recent version
should be used
In GB the following Codes of Practice apply:
Standard
Scope
BS 6891
Gas Installation.
BS 5546
Installation of hot water supplies for
domestic purposes.
BS 5871
Installation of gas fires, convectors and
fire/back boilers.
BS 5440 Part 1
Flues.
BS 5440 Part 2
Ventilation.
BS 6798
Installation of gas fired hot water boilers.
BS 5449 Part 1
Forced circulation hot water systems.
In IE the following Codes of Practice apply:
Standard
Scope
I.S. 813
Domestic Gas Installations.
The following BS standards give valuable additional information;
BS 5546
Installation of hot water supplies for
domestic purposes.
BS 5449 Part 1
Forced circulation hot water systems.
IMPORTANT
- The addition of anything that may
interfere with the normal operation of the
appliance without express written permission
from the manufacturer or his agent could
invalidate the appliance warranty. In GB this
could also infringe the
G
AS
S
AFETY
(Installation
and Use)
R
EGULATIONS
.
Safe Installation
The appliance is suitable only for installation in
GB and IE and should be installed in
accordance with the rules in force.
In GB, the installation must be carried out by a
CORGI Registered Installer. It must be carried
out in accordance with the relevant requirements
of the:
• Gas Safety (Installation & Use) Regulations.
• The appropriate Building Regulations either
The Building Regulations, The Building
Regulations (Scotland), Building Regulations
(Northern Ireland).
• The Water Fittings Regulations or Water
Byelaws in Scotland.
• The Current I.E.E. Wiring Regulations.
Where no specific instructions are given,
reference should be made to the relevant British
Standard Code of Practice.
In IE, the installation must be carried out by a
competent Person and installed in accordance
with the current edition of I.S. 813 ‘Domestic Gas
Installations’, the current Building Regulations
and reference should be made to the current
ETCI rules for electrical installation.
Read the instructions before installing or using
this appliance.
Never hang clothes or other items over the
appliance.
In case of gas leaks
1.
If a gas leak is found or suspected,
turn off
the gas supply at the meter immediately and call
your gas supplier.
Servicing your boiler
1. We strongly recommend that your Bermuda is
serviced annually by a competent person for
economic and safety reasons. Your Installer will
be able to advise you.
Electricity supply
1. THIS APPLIANCE MUST BE EARTHED
A standard 230 volt ~ 50Hz supply is required.
The appliance must be protected by a 3 amp fuse.
Fault
1. If it is either known or suspected that a fault
exists on the appliance, it
must not be used
until the fault has been corrected by a
competent person.
“Benchmark” Installation, Commissioning and Service Record
Log Book
Please ensure that your installer has completed the Installation and
Commissioning sections of the Log Book and hands the Log Book over.
The details of the Log Book will be required in the event of any warranty
work. Keep the Log Book in a safe place and ensure that the relevant
sections are completed at each subsequent regular service visit.
All CORGI registered installers carry a CORGI identification
card and have a registration number. Both should be recorded
in your boiler Log Book. You can check your installer is
registered by telep44 (0)1256 372300 or writing to:-
1 Elmwood,
Chineham Business Park,
Crockford Lane,
Basingstoke. RG24 8WG
Warnings
