11.2 Fitting the Anthem and Camden fascia.
1.
The fascia is supplied in three pieces.
Carefully remove the three fascia pieces from
the packaging. Remove any protective film.
2.
The magnets used to locate each fascia trim
should already be positioned on the rear of each
trim. Each fascia trim should have two magnets.
If the magnets are not fitted then locate one
magnet centrally at each end of the trims.
3.
Locate the side fascia trims as in figure 37.
4.
Locate the top fascia trim as in figure 37.
11.3 Fitting the firefront castings on ‘Dream’
and ‘Sonnet Plus’ models.
1.
Place the firefront casting centrally on top of
the hearth in front of the fascia.
2.
Place the bottom front cover
casting in position.
11.4 Fitting the firefront castings
on the ‘Anthem’ model.
1.
The ‘Anthem’ firefront is
supplied with two brackets. These
brackets are to hang the firefront
casting to the burner tray.
2.
Remove the two M4 screws from
the rear of the firefront casting (See
figure 38). The top section of the
casting will detach from its support
leg.
3.
Position the brackets as in figure
38 and secure the brackets and
casting top section in place using
the two screws previously removed.
4.
Hang the firefront casting onto
the burner tray front (See figure 39)
5.
Locate the lower firefront casting as in figure 40.
11.5 Fitting the ‘Camden’ firefront.
1.
Place the firefront centrally on top of the hearth in front of the fascia.
Page 32
INSTALLER GUIDE
Figure 38. Fitting the hanging brackets to the
firefront.
Figure 37. Fascia location
