6. PREPARING FOR INSTALLATION
Check ignition spark.
Before attempting to install, it is worth checking that
the piezo electric spark ignition system operates
satisfactorily.
To initiate the spark, depress the control knob and
while keeping it depressed, turn anticlockwise through
approximately 60° to the “PILOT/IGN” position. A
spark should track from the electrode pin to the
thermocouple tip. If there is no spark or incorrect
tracking, check the spark gap between the electrode
wire and thermocouple tip (See figure 7). If the spark
gap is correct, check the ignition wiring.
In the majority of cases, the burner
unit will need to be detached
.
Detach
the burner unit from the convection
box by removing two screws (See
figure 8).
Page 16
INSTALLER GUIDE
Figure 7. Pilot ignition system.
Figure 8. Burner unit removal.
