The heater must be fixed into position to prevent it from being tipped over
The following fixing options are available:
Screw Fixing
Wire Fixing
Spacer Frame (Not available on
Dream
and
Bolero
models)
If fitting the heater into a fireplace or surround opening, try the heater in the opening to
ensure that it will fit.
If fitting the heater onto a decorative hearth surface such as marble or tile it is advisable
to protect the hearth surface. Do not drag the heater across the surface of the hearth as
this may scratch the hearth surface.
Method A - Screw fixing.
Note - If fixing to marble it is recommended that Method B - ‘Wire fixing’ is used.
Drilling marble without the correct tools and
experience may result in the marble cracking.
1.
Place the heater into the fireplace or surround
opening
.
Make sure that the heater is in the middle of
the surround or fireplace.
2.
There are two slotted holes in the top of the heater
(See figure 5). Mark through the slotted holes so that
their position is clear when the heater is removed.
3.
Remove the heater
4.
Drill an appropriate size hole in each of the marked
positions. Insert wall plugs into the drilled holes.
5.
Place the heater so that the slotted holes are in line
with the wall plugs in the fixing surface.
6.
Screw and secure the heater with two
‘A’ screws (See figure 4).
Method B - Wire fix.
This method of fixing needs a fireplace
opening and is recommended when
fixing the heater to a marble surround or
where the wall or brickwork is in poor
condition.
1.
The fixing kit supplied with the heater
includes a steel wire and eyescrew (See
figure 4). These can be used to secure the
heater to the back of a fireplace opening.
Page 9
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2005.
Figure 6. Eyescrew position.
Figure 5. Slots for screw
fixing.
