2.
Mark the eyescrew position on the centre line at the back of the fireplace opening and
at a height of 533-560mm (21 inches - 22 inches) (See figure 6).
3.
Drill an appropriate size hole in the marked position.
4.
Insert a wall plug into the drilled hole.
5.
Screw the eyescrew into the wall plug.
6.
Position the heater in front of the fireplace opening.
7.
At the top of the heater there are four small holes, two each side of the heater (See
figure 7- Item 1). From the front of the heater, thread about 50mm ( 2 inches) of the
steel wire into the inside small hole on the left side of the heater (See figure 7 - item 2).
8.
Thread the other end of the wire
through the remaining small hole on the
left hand side of the heater. Continue to
push the wire through this hole until there
is only a small loop of wire at the front of
the heater (See figure 7 - item 3).
9.
At the back of the heater there will be a
long piece and a short piece of wire
coming through the two holes. Hold the
short piece and give the long piece a
gentle tug. This will secure the steel wire.
Take the long piece and thread this
through the eyescrew in the back of the
fireplace opening (See figure 7 - item 4).
10.
From the back of the heater thread the
long piece of steel wire through the outer
small hole on the right hand side of the
heater (See figure 7 - item 5).
11.
Locate the heater in the fireplace
opening, then from the front of the heater,
gently pull the steel wire on the right hand
side to gather up the excess until the
heater is secure. Thread the wire through
the remaining small hole to lock the wire
and heater in place (See figure 7 - item 6).
Page 10
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2005.
Figure 7. Steel wire fixing (Detail at top of
heater may differ from that shown)
