6.3.3
Locating the burner.
!
Place the burner assembly in
position (If installing into a 'Liberty'
casting the rear support plate on the
burner must touch the rear inner edge
of the casting. See figure 9).
!
Mark on the fireplace floor the
position of the fixing holes in the
bracket that is attached to the rear of
the front leg. There are two holes in
this bracket to prevent burner
movement in use (See figure 10).
!
Remove the burner assembly.
!
Using a 6mm masonry drill, drill
into the hearth at the marked
position.
!
Insert the supplied screw
plugs.
!
Remove the fixing bracket
from the front leg by undoing
the screw.
!
Place the bracket in
position on the fireplace floor
and fix in position using the
woodscrews provided.
!
Place the burner assembly
back in position and attach to
the bracket by refitting the
screw.
7. BURNER AND SUPPLY PIPE INSTALLATION
A nut and olive is provided for an 8mm-pipe inlet connection directly to the gas control.
The inlet ‘T’ connector can be rotated to allow a connection from any direction. The
inlet ‘T’ connector includes a valve for isolating the gas supply. Note that the centre of
the appliance inlet ‘T’ connector is 25mm above the fireplace floor. The inlet ‘T’
connector should be fitted to the supply pipe at this stage.
The supply pipe must be rigid material. Flexible pipe must not be used. Connect the
supply line to the appliance.
Page 16
INSTALLER GUIDE
Figure 10. Locating the burner
Figure 9. Locating the burner into the Liberty
casting.
