Bavono BVS8016-A, Руководство пользователя, Страница: 31 / 66

DVR User Manual
26
Fig 4-23 System Configuration-Alarm Out
Step 2 : Input relay name and select hold time.
Step 3 : Enter into Schedule tab. This will go into schedule setup interface. The setting steps
for schedule for alarm out are similar to normal schedule setup (see Chapter 4.4.1 for details).
This step is very important for alarm out. Even if you have enabled alarm out in the motion
based alarm or sensor based alarm, you will not see the result of alarm out if no schedule is
added here.
To set up buzzer:
Step 1 : Enter into Menu

Setup

Alarm Out

Buzzer.
Step 2 : Checkmark Buzzer and set buzzer alarm hold time. This would trigger the buzzer
when the system is on an alarm.
4.6 Network Configuration
Network configuration includes five submenus: network, sub stream, Email, server and other
settings. Network settings must be configured if DVR is used for monitoring over network.
4.6.1 Network
To set up network:
Step 1 : Enter into Menu

Setup

Network

Network tab. Refer to Fig 4-24:
Step 2 : Set HTTP port. The default HTTP port is 80. If the value is changed, you shall add the
port number when typing IP address in IE address blank. e.g. If HTTP port is set to 82 and IP
address is http://192.168.0.25
,
you should input the following IP address:
http://192.168.0.25:82 into IE browser.
Step 3 : Set server port. The default server port is 6036.
Step 4 : Connect internet. There are three ways to connect internet.