Description of the Software Modules and Parameters
Parameter manual
b maXX
BM5800
Document No.: 5.16029.03
59
3
139.2
Baudrate
Baud rate for serial communication
Valid baud rates: 9600, 19200, 38400, 57600, 115200, 230400, 460800, 921600
Each time the controller is switched on, the baud rate is set to 38400.
139.4
Number of axes
With setting number of axis = 1, a double axis can operate as a single axis. Then the
axis 2 is switched off. The numbering of the following axes is not affected thereof.
139.23
System command
System commands in the controller are triggered by writing to this parameter.
139.25
Switch-on time
If the system is started this parameter saves the value of system clock (
NOTE!
m
The parameter Number of axes is writable from password-level 1 on.
m
After the number of axes were adjusted, the parameters must be saved and the
drive must be switched off and on again.
m
The settings of a parameterized axis 2 are lost, if axis 2 is switched off with number
of axes = 1.
m
Encoder 2 cannot be used, if axis 2 is switched off.
After switching on:
m
Axis 2, which is switched off, stays in drive status "Not Ready-to-Start" (
= 0)
m
References on axis 2 (for example the writing of a digital input to a target parame-
ter from axis 2) results in error messages within the data set management. In this
case check
. Correct the parameter settings, which are concerned. Save
the parameters. Switch off and on again.
m
Motor number is set to the value of the number of axes at
double axes.
Содержание b maXX BM5800
