PAGE 24
TP10494A
Figure 4.5-1
Feed Table
Hoses
Air
Vacuum
Pump
Hoses
Figure 4.5-2
Plug the feed table into the side of the frame.
(See
Figure 4.5-2)
Feed Table Plug
The center notches should seat on the second set of
locating pins. Pivot the fold plate hold-downs back into
position to secure the fold plates.
Turn the handwheel to be sure that the fold plates
are properly installed and not rubbing on the fold rolls.
Plug the fold pan connectors into the side frame.
(See figure 4.6-1)
5.0 ELECTRICAL ACCESS
WARNING
Turn off the main power switch (See figure 5.0-1).
Unplug the AC power cord before attempting any electri-
cal repair.
The electrical controls are located in the left-hand
side cover. The handwheel must be removed for access
to these controls.
The cover can be removed by taking out the four
screws located on the inside of the frame.
Figure 4.6-1
4.6 Fold Plate Installation
WARNING
Unplug the AC power cord when installing or
removing fold plates.
The fold plates are interchangeable.
Each fold plate has an open end which faces toward
the fold rolls.
To install the fold plates, pivot the fold plate hold-
downs out of the way and slide the fold plate in position
so that the slots in the leading edge of the fold plate
engage the two locating pins in the side frames.
Figure 5.0-1
Main Power/Reset
Switch
#2 Pan Plug
#2 Pan Lock
Do not operate machine with-
out feeder in place!
Do not operate machine with-
out fold plates in place!
