Baumer HMG 10-SSI, Инструкция по установке и эксплуатации

Страница: 16 / 36

MOUNTING / HOW TO PREVENT MEASUREMENT ERRORS
12/32
MB244EN - 11171691, 16A3, Baumer_HMG10-SSI_II_EN
4.5 How to prevent measurement errors
To ensure that the encoder operates correctly, it is necessary to mount it accurately as
described in section 4�1 to 4�4, which includes correct mounting of the torque arm�
The radial runout of the drive shaft should not exceed 0�2 mm (0�03 mm recommended),
to prevent an angle error�
An angle error may be reduced by increasing the length of L1*� Make sure that the length
L2 of the torque arm, see below, is at least equal to L1**�
The angle error Δρ
mech
can be calculated as follows:
Δρ
mech
= ±90°/π · R/L1
with R: Radial runout in mm
L1:
Distance of the torque arm to the center point of the encoder in mm
Example:
For R = 0.06 mm and L1 = 69.5 mm the resulting angle error Δρ
mech
equals ±0�025°�
i
For more information, call the telephone hotline at +49 (0)30 69003-111
L1
L2 (≥L1)
* For this different braces for the torque arm are available on request�
** If L2 < L1, L2 must be used in the calculation formula�