Fitting the chimney
13)
Separate the two
chimney sections (
G
and
H
).
o
Rest the bottom of
chimney section
G
on the
top of the hood. Making
sure that the holes at the
bottom of it, line up with
the securing holes on top
of the motor housing.
o
If you want to install the
appliance at its minimum
height (i.e. only using one
section of chimney), then
you should complete
steps 14-18 using
chimney section
G
only.
14)
Lift chimney section
H
upwards to the desired height. You must
ensure that it is perpendicular to the hood.
o
Mark the side measurement of both sides of chimney section
H
on the wall with a pencil and then remove chimney sections
G
and
H
.
15)
Take the fixing bracket (
L
) and place it between the two pencil
marks that you made in step 14. Use a spirit level to ensure that the
bracket is level before marking the position of the screw holes.
o
Keeping the bracket in contact with the wall, use a pencil to
mark the position of the holes at either end of the bracket on the
wall.
24
Содержание Pythagora P25SS
Страница 1: ...P25SS 90 cm Cooker Hood ...
Страница 30: ...30 ...
Страница 31: ...31 ...
Страница 32: ...32 32 ...
