Baumatic BWD1206SL-W, Руководство пользователя

Страница: 32 / 36

-- °C
o
No heat (cold wash).
0
o
No spin
800
o
Status information: spin speed 800 rpm.
L--1
o
Manually selected code when laundry weight in less than 1 kg.
L--A
o
Manually selected code when drum is nearly full.
End
o
Program is finished.
If a fault code reappears after following the above
advice and clearing the fault code. You should turn
the washing machine off using the POWER button.
Disconnect the appliance from your mains supply.
Then arrange for an engineer to attend the
appliance. You should contact the Baumatic
Service Department on (0118) 933 6911.
IF AN ENGINEER ATTENDS DURING THE GUARANTEE
PERIOD AND FINDS THAT A FAULT HAS BEEN CAUSED
BY AN ITEM ON THE ERROR CODE LIST, WHICH COULD
HAVE BEEN CLEARED BY THE CUSTOMER. THEN YOU
MAY BE LIABLE FOR THE COST OF THE SERVICE CALL.
General troubleshooting
Problem Possible causes Possible solutions
Washer-dryer fails
to operate.
o
Poor connection to the
power supply.
o
Power failure.
o
The washer door is not
properly closed.
o
Machine has not been
switched on.
o
Check connection to
the power supply.
o
Check the power
supply.
o
Make sure the
washer door is
closed properly.
o
Make sure the
machine is switched
on.
Washer-dryer
cannot be filled
with water.
o
Water tap is not turned on.
o
Water pressure is less than
0.03 MPa.
o
The inlet hose is kinked.
o
Water supply failure.
o
The program selection dial
is not properly set.
o
The washer door is not
properly closed.
o
Turn water tap on.
o
Check water
pressure.
o
Check the inlet hose
for bends.
o
Ensure the water
supply is connected.
o
Make sure the
program selection
dial is properly set.
o
Make sure the
washer door is
closed properly.
Machine is
continually filling
and draining.
o
The height of the drain
hose is below 80 cm.
o
The drain hose is in water.
o
Make sure the
height of the drain
hose is within 80 –
32