Set up instructions for the 714XLT
Baumfolder Corporation P.O. Box 728 1660 Campbell Rd, Sidney, Ohio USA 45365 Copyright © 2002
Phone 1-800-543-6107 or 1-937-492-1281 Fax 1-937-492-7280 email: [email protected]
8. Load the feeder, printing face up for header in, or face down for
header out, and run three signatures (sheets). You may have to
adjust the vacuum and or the blow. To adjust the vacuum, turn the
right knob on the on the right guard counter clock-wise to increase
and clock-wise to decrease vacuum. The knob on the left is the
blow adjustment.
9. Make any adjustments necessary with the micro adjustments. If you have a dog-ear, (corner of the
inside fold turned back), adjust the length of the inside fold so it is approximately 1/16” to 1/8” from
the second fold. Lengthening or shorting the number one fold plate can accomplish this.
10. If for any reason you will be folding in the second unit (8 page), always score after the fold is formed
in the slitter shafts. The score should be located where the second fold will be made.
11. If you want to do the second pass on the same folder, score on the first pass
through the folder. Move the side guide over close to the vacuum feed wheel.
The feed wheel should pick up the folded sheet within ¾” of the fold. You
may have to remove the front blow bar to get the side guide close enough to
the vacuum wheel. Turn the adj. knob on the side of the feeder to blow air
into the folder side (in the picture shown, that would be the right side)
** End of basic setup instructions *