37
Water stop anti-flooding
system
(depending on model)
•
Screw the hose to the water
supply tap. Turn the tap fully
on and check the water-
tightness of the connection.
•
The appliance must not be
connected to the mixing tap
of a non-pressurized water
heater!
•
The inlet hose and the plastic
enclosure contain electrical
components:
Do not cut the hose and do
not immerse the enclosure
in water.
•
If the flexible hose is
damaged, unplug the
appliance from the mains
immediately and replace it.
If the flexible hose is too short,
replace it with a 3 m Water
Stop hose (available from
After-Sales Service or from
your dealer). This operation
must be carried out exclusively
by a qualified technician.
Connect the water drain
hose
1.
Unhook the drain hose from
the left and right hose
connections, see arrow
A
in
figure.
Important:
Do NOT loosen the drain
hose connection from the
left side, see arrow B in
figure.
Otherwise, there is the
risk of leakage and of scalding
with hot water.
2.
Fix the “U” bend (
C
) to the
free end of the drain hose.
Connect the drain hose to the
siphon or hook it over the edge
of a sink with the “U” bend.
Small hand basins are not
suitable.
The edge of the sink must be no
more than 100 cm from the
floor.
If you fix the drain hose to a
drainage stand pipe, the
internal diameter of the drain
pipe should be 3 cm minimum.
To avoid a syphon effect, the
end of the drain hose should be
55 cm min. from the floor.
If you need to add an
extension, use a flexible hose
of the same size and secure the
unions with screw-on hose
clips.
Maximum overall drain hose
length: 2.50 m.
Maximum drain height
(“U” bend): 100 cm.
Minimum drain height: 55 cm.
Important:
Make sure there are no kinks in
the drain hose and take
precautions against it falling
while the appliance is running.
A
B
C
