30
Draining Residual Water
Care and Maintenance
When should I drain residual
water (draining problem)?
•
Before transporting
(moving) the machine.
•
If the appliance is installed in
a room subject to sub-zero
temperatures. It is best in
this case to drain the
machine after every wash.
•
If the display shows “FP”
(draining problem).
1.
Stop the appliance and
unplug it.
2.
Turn off the tap, disconnect
the water supply hose from
the machine and allow the
water to drain into a basin.
3.
Open the foreign body trap,
let the water drain into a
small shallow basin and
close the trap.
4.
Release the drain hose then
open the fixing clip located
at the rear of the machine
(see arrow A).
5.
Let the residual water flow
into a shallow basin.
6.
Wait until the flow stops.
7.
Fix the drain hose again
with the clip and replace it
with the U-bend.
8.
Reconnect the water supply
hose and the power plug.
Important:
•
After draining the residual
water, screw on the
machine’s water supply hose
by hand. Check water-
tightness of appliance
connections by turning the
tap completely on.
Detergent dispenser
1.
Push in the buttons on each
side of the dispenser.
2.
Pull the dispenser towards
you and remove.
A small quantity of water
can remain in the dispenser.
It is advisable to carry the
dispenser in an upright
position.
3.
Wash the dispenser using
running water.
You can also remove the
siphon caps in the dispenser
for cleaning.
4.
Replace the siphon caps in
the dispenser (if removed).
Make sure that they lock in
place.
5.
Replace the dispenser by
locating the bottom tabs in
the lid holes and pivot until
both of the upper buttons
lock.
Note: ensure that the
detergent dispenser is
correctly reinstalled.
A
