Place the measuring tool on the wall holder and horizontally align it.As
an example, you can use the laser point to align socket outlets on
different walls or hang up wardrobe hooks at the same height.For this,
turn the upper part of the wall holder 13 with the measuring tool, and
not the measuring tool on the wall holder.
When turning, pay attention not to touch the measuring tool, otherwise
its position could be changed.
Working with tripod (recommended): Align the laser beam to the
requested height.
Project or check the height at the target location.
Working without tripod: Determine the height difference between the
laser beam and the height art the reference point.Project or check the
measured height difference at the target location.
Checking Horizontal / Vertical Lines with the
Spirit Levels ( see figure G)
The measuring tool can also be used as a carpenter’s spirit level for
checking vertical and horizontal lines, for example to align a washing
machine or a refrigerator. Position the measuring tool with the alumini-
um supporting surface 2 on the surface to be checked.When placing
on horizontal surfaces, the aluminium supporting surface 2 must face
downward, when placing against vertical surfaces, the laser ourltet
opening for line operation 5 must face upward.
Working Advice
For marking, always use only the centre of the laser point or the laser
line. The size of the laser point as well as the width of the laser line
change with distance.
Fastening/aligning with the wall holder
With the wall holder 13, the measuring tool can be fastened as follows:
Line operation: Place the wall holder via its recess on the backside
onto a screw head slightly projecting out of a wall. Fasten the measur-
ing tool with the magnets 9 to
the metal surface for line operation 14 of the wall holder.
Turn the upper part of the wall holder to align the measuring tool as
required.
Point operation: Place the wall holder via tehtripod mount 17 onto the
1/4” male thread of the tripod and screw the locking screw of the
tripod tight. Align the tripod roughly.
When working without tripod, place the wall holder on a surface that is
as horizontal as possible.
Position the measuring tool with the aluminium supporting surface 2
facing down on the wall holder.Attach it via the left magnet 9(viewed
from the front side of the measuring tool) to the metal surface for point
operation 15 of the wall holder.
Horizontally align the upper part of the wall holder with adjusting screw
16 of the wall holder and spirit level 4 of the measuring tool.Turn the
upper part of the wall holder
by 90` and repeat the alignment.
LASER SPIRIT LEVEL
