BAUKER CGT18LW, Оригинальное руководство пользователя

Страница: 15 / 20

EN-15
Repeat above until you hear the lines hitting against the line cutter. (Do not repeat this procedure more
than 6 times)
5. TO MANUALLY FEED THE LINE (SEE FIG. I)
If required, line can be fed out manually. Before manually feed, remove the battery first. To operate,
press and release manual line feed button (14), while gently pulling out the lines until the lines reach the
line cutter. If the line extends past the line cutter, too much line has been fed out. If too much line is fed
out, remove the spool cap and turn spool counter-clockwise until the line is at the desired length.
To remove the cap
Press and hold in the two latches (See Fig. J). Pull cap away from the spool holder. When refitting the
spool cap. Keep all areas of the cap and spool holder clean. Replace the cap, pressing firmly down
towards the spool holder to ensure cap is fully located. Check that the cap is correctly fitted by trying to
remove it without depressing the two latches.
To changing the spool (SEE FIG. K)
NOTE: For your convenience it is recommended you buy replacement spools with the trimmer line
preinstalled.
Remove Spool Cap Cover. Remove the old Spool from Spool Holder. Clear any broken line or
cutting debris from the spool area. Pull the line from the new replacement Spool through the
eyelet of the Spool Holder. Place new Spool into the holder with the cut out areas of the Spool
facing inward or down. When installed into the Spool Holder, the smooth side of the Spool
should be visible. Release line from cleat on the Spool. Refit the Spool Cap Cover.
To Manually Wind line (See Fig L1-L3)
Important! Your trimmer is designed to use only line with a maximum diameter of 1.65mm.
Take approximately 3m of line. Insert 15mm of line into the spool holes and wind line in the direction
of the arrows on the top of the spool. (See Fig. L1, L2) Leave approximately 100mm of line unwound
and place it into the cleat. Care should be taken to ensure that the line is neatly coiled on the spool.
(See Fig. L3) Failure to do so will impair the efficiency of the automatic line feed. Then fit the spool as
described above in “To changing the Spool”.
STORING YOUR GRASS TRIMMER
Always remove the battery pack from your trimmer after use.
Store in a dry place where the trimmer and battery can be protected from damage.
MAINTENANCE
Remove the battery before carrying out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical cleaners to clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you may see sparks through the ventilation slots.
This is normal and will not damage your power tool.
If the charger supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.