BAUKER CDI218W1, Оригинальное руководство пользователя

Страница: 18 / 20

EN-18
13. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended for the power tool cannot be subject to overload. When the load is too high or
the allowable battery temperature is too hot, the electronic control switches off the power tool until the
temperature is in the optimum temperature range again.
14. PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging by the “Discharging Protection System”. When
the battery is empty, the machine is switched off by means of a protective circuit: The inserted tool no
longer rotates.
15. DISPOSAL OF AN EXHAUSTED BATTERY PACK
To preserve natural resources, please recycle or dispose of the battery pack properly. This
battery pack contains Lithium batteries. Consult your local waste authority for information
regarding available recycling and/or disposal options. Discharge your battery pack by operating
your drill, then remove the battery pack from the drill housing and cover the battery pack
connections with heavy-duty adhesive tape to prevent short circuit and energy discharge. Do not
attempt to open or remove any of the components.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of the trigger, is positioned in the lock function.
Unlock the forward/reverse rotation control by putting it into the required rotation position. Push the
trigger and the drill will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring, you can find the torque-adjusting ring between
the chuck and the drill body. Position 1 is the lowest torque (screw driving force) and position 21 is
the highest torque (screw driving force). Position is for drill operation. Position is for hammer drill
operation. Regulate the torque adjusting ring to a higher position to reach the best result.
3. I CANNOT FIT THE BATTERY INTO THE BATTERY CHARGER. WHY?
The battery can be inserted into the charger only in one direction. Turn the battery around until it can
be inserted into the slot.
4. REASONS FOR DIFFERENT BATTERY PACK WORKING TIMES
Charging time problems, as above, and having not used a battery pack for a prolonged time will
reduce the battery pack working time. This can be corrected after several charge and discharge
operations by charging & working with your drill. Heavy working conditions such as large screws into
hard wood will use up the battery pack energy faster than lighter working conditions. Do not re-charge
your battery pack below 0 oC and above 45 oC as this will affect performance.
MAINTENANCE
Remove the battery pack from the tool before carrying out any adjustment,
servicing or maintenance.
Your tool requires no additional lubrication or maintenance.