BAUKER CDI218W1, Оригинальное руководство пользователя

Страница: 16 / 20

EN-16
OPERATION
1. INSTALLING AND REMOVING THE BATTERY PACK
a) TO REMOVE THE BATTERY PACK (SEE FIG. B1)
Depress the Battery Pack Release Button firmly first and then slide the Battery Pack out from your tool.
b) TO INSTALL THE BATTERY PACK (SEE FIG. B2)
Slide the fully charged Battery Pack onto the tool with sufficient force until it clicks into position.
2. ON / OFF SWITCH (SEE FIG. C)
Depress the On/Off switch to start and release it to stop your drill.
The on/off switch is fitted with a brake function which stops your chuck immediately when you quickly
release the switch.
It is also a variable speed switch that delivers higher speed and torque with increased trigger pressure.
Speed is controlled by the amount of switch trigger depression.
Warning: Do not operate for long periods at low speed because excess heat
will be produced internally.
3. SWITCH LOCK (SEE FIG. D)
The switch trigger can be locked in the OFF position. This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger, place the rotation control in the center position.
4. REVERSIBLE (SEE FIG. E1, E2)
For drilling and screw driving use forward rotation marked “ ” (lever is moved to the left). Only use
reverse rotation marked “ ” (lever is moved to the right) to remove screws or release a jammed
drill bit.
Warning: Never change the direction of rotation when the chuck is rotating, wait until it has stopped!
5. TWO-SPEED GEAR CONTROL (SEE FIG. F)
The drill has a two-speed gear control designed for drilling or driving at LO (mark is 1) or HI (mark is
2) speeds. A slide switch is located on top of the drill to select either LO or HI speed. When using the
drill in the LO speed range, the speed will decrease and the drill will have greater power and torque.
When using the drill in the HI speed range, the speed will increase and the drill will have less power and
torque.
Gear I
Low speed range: for screwdriving or working with large drilling diameter
Gear II
High speed range: for working with small drilling diameter
Warning: To prevent gear damage, always allow the chuck to come to a
complete stop before changing the direction of rotation or the two-speed gear
control.
6. AUTOMATIC SPINDLE LOCK (SEE FIG. G)
The automatic spindle lock allows you to use it as a regular screwdriver. You can give an extra twist
to firmly tighten a screw, loosen a very tight screw or continue working when the battery energy has
expired. For manual screwdriver purposes, the chuck is automatically locked when the tool is off.
7. CHUCK ADJUSTMENT (SEE FIG. H )
To open the chuck jaws rotate the front section of the chuck. Insert the drill bit between the chuck jaws
and rotate the front section in the opposite direction. Ensure the drill bit is in the center of the chuck
jaws. Finally, firmly rotate the front chuck section in the opposite directions. Your drill bit is now clamped
in the chuck.