Era mod. 2010 (v. 2.0)
14
2019
19.
MECHANICAL RISKS
The following situations are considered dangerous for the operator:
1.
using the machine for different purposes other than ironing;
2.
when you continue to use the machine after the safety valve has been activated
(steam pressure inside the boiler is too high, check the manometer).
20.
THERMAL RISKS
The following situations are considered dangerous for the operator:
1.
touching the iron base when in function;
2.
when discharging the boiler without following the instructions in the manual;
3.
when you direct the jet of the steam toward people or animals.
Caution: Thermal danger!
Incandescent iron plate
Some parts of the machine can become extremely hot: use it very carefully and
disconnect the plug when not in use.
It is advisable to proceed with the cleaning of the machine only when it cools down.
21.
INTERVENTIONS AND SMALL REPAIRS
1.
It is recommended to replace the cover (Prontotop):
-
when
“MAINTENANCE SUGGESTED”
is displayed;
-
when the vacuum of the board in unsatisfactory or if stains appear on it. The
stains can appear also if the operator uses too much steam and/or doesn’t use
vacuum enough (in this case decrease the steam flow and use more vacuum).
The replacement of the cover must be carried out with the ironing board switched
off and cold. N.B.: the Prontotop can be washed 1 or 2 times.
2.
Immediately replace the electric wire when it is damaged. The wire is supplied by
the manufacturer or authorized service centres. Do not use the equipment with a
damaged electric wire.
3.
Check that there are no losses from the discharge tap. If there are, replace it.
4.
Clean the air vacuum/exhaust duct, the fan of the vacuum/blowing motor and any
air intake from accumulations of dust which could reduce the vacuum/blowing
performance.
22.
CLEANING OF THE WATER FILTER
The cleaning of the water filter (fig. 4) is to be done whenever the warning
“MAINTENANCE
SUGGESTED”
is displayed. If the water is full of impurities, cleaning should be done more
often.
