Era mod. 2010 (v. 2.0)
11
2019
To gain access to the fuses the main switch must be on pos. “0” and the four screws
must be unscrewed from the blue panel. The position of the fuses is indicated in Fig.
2.
In order to replace the broken fuses of the electronic board unscrew them by using a
screwdriver, exerting a slight pressure and rotate.
For the replacing of the electricity grid fuses just open the panel.
Warning:
substitute fuses only with ones of the same type and performance.
15.
GENERAL WARNINGS
1.
Avoid connecting the device to multiple sockets and/or extensions which are not
suitable to its power.
2.
Keep children away from the ironing board, both when it is on and off.
3.
Place the equipment on a steady surface indoor with a temperature between
+10°C and +40°C. Do not place it outside or expose it to the action of
atmospheric agents.
4.
The operator must never leave the ironing board unattended when plugged into
the electricity grid.
5.
When in use, do not bring it near thermolabile or inflammable parts.
6.
Always turn off the machine by pressing the specific main switch before
disconnecting it from the electricity grid.
7.
Always disconnect the plug from the electricity grid when the equipment is not in
use and before any maintenance or cleaning procedure.
8.
Keep the electric wire away from hot surfaces and be careful not to crush it under
doors or to step on it.
9.
Never use the ironing board without the cover (Prontotop) properly positioned.
10.
Do not get on the linen support, sit on the board, nor lean against the sleeve arm:
the ironing board has been specifically designed for ironing of garments.
11.
Never leave garments on the board when it is switched on and unattended
because they might get spoilt or even burnt.
12.
Never leave the iron on the board or on the garments when it is switched on.
Fig. 2
Board resistence
F15AL 250V
(6,3x30)
Light, steaming
F4AL 250V
(5X20)
Vacuum motor
T5AL 250V
(5X20)
Blowing motor
T5AL 250V
(5X20)
Pump
T5AL 250V
(5X20)
Iron 1
F5AL 250V
(5X20)
Iron 2
F5AL 250V
(5X20)
Gun
F4AL 250V
(5X20)
Ironing arm
F2AL 250V
(5X20)
Contactor
F2AL 250V
(5X20)
