Battipav Expert 500, Руководство по эксплуатации

Страница: 21 / 37

33
Battipav srl Battipav srl GB
MARKER ADJUSTMENT
In case the marker is not aligned with the cutting line,
its correct alignment can be adjusted.
In order to correctly position the marker, proceed as
follows:
29
• loosen the bulb locking screw so that it can be
moved;
29
• insert the 5 mm Allen wrench provided in the
hexagonal slot located on the bulb;
30
• using the Allen wrench, turn the bulb until
aligning the mark with the tool cutting line.
CAUTION
31
DURING THE ADJUSTMENT OPERATIONS,
MAKE SURE THAT THE LINE PRODUCED
BY THE MARKER DOES NOT REACH THE
OPERATOR’S EYES.
CAUTION
31 ALWAYS KEEP A SAfETY DISTANCE BETWEEN
THE OPERATOR’S EYES AND THE END Of THE
LINE.
CAUTION
DIRECT EXPOSURE TO SUNLIGHT MAY REDUCE
THE LASER MARKER EffECTIVENESS.
IT IS THEREfORE ADVISABLE TO USE THE
MACHINE INDOORS.
CAUTION
THE MANUfACTURER DECLINES ANY LIABILITY
fOR THE USE Of THE LASER MARKER IN
APPLICATIONS OTHER THAN THE INDICATED
APPLICATION.
RESIDUAL RISK
During the design phase, BATTIPAV SRL paid
particular attention to the aspects that may generate
risks for the safety and health of operators.
In spite of this, there are still some potential risks,
which are described below:
CAUTION
• Danger of presence of electric current:
The machine has an internal electric system.
CONNECT THE MACHINE TO A SYSTEM WITH
DIffERENTIAL PROTECTION AND EffECTIVE
EARTH WIRE.
CAUTION
• Danger of prolonged exposure to noise:
The continuative use of the machine causes an
exposure to noise levels above 85 dB (A).
OPERATORS MUST USE PROPER EAR
DEfENDERS.
CAUTION
• Danger of exposure to fragments of
materials. OPERATORS MUST WEAR
PROTECTIVE GOGGLES.
CAUTION
• Danger of accidental contact with the moving
tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE
GLOVES
ALWAYS STAY IN THE WORKING POSITION (Pos.
1 picture 22) DURING THE MACHINE OPERATION
PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the
machine stop.