Battipav Expert 500, Руководство по эксплуатации

Страница: 17 / 37

29
Battipav srl Battipav srl GB
DIAMOND BLADE WET CUTTING
LASER/SECTORS:
cement, natural stones, granite, abrasive materials
THE TOOL / MATERIAL TO BE CUT MATCHES ARE
PURELY INDICATIVE.
ALWAYS fOLLOW THE INTENDED USE
INDICATIONS PROVIDED BY THE CUTTING TOOL
MANUfACTURER BEfORE ANY APPLICATION.
Water recirculation pump: S3 230V 50/60Hz
The noise level of the machine has been measured in
compliance with standards UNI EN12418, EN3744.
LW - SOUND POWER LEVEL = 88.1/0.6 dB(A) /mW(A)
LOP - SOUND POWER LEVEL AT THE OPERATOR
POSITION= 77.6 dB(A)
LOP Max - PEAK SOUND POWER LEVEL AT THE
OPERATOR POSITION= 85.2 dB(C)
Measurements have been performed without load
and at maximum speed using a cutting tool with a
diameter of 600 mm, sectors type, Art. 896C.
In working conditions, the machine creates a noise
emission above 85 dB(A).
The level of vibration transmitted to the hand-arm
system has been measured according to standard
UNI EN ISO 5349-1 while cutting poroton bricks.
(L 275 x W 190 x H 135 mm) using a cutting tool with
a diameter of 600mm, sectors type, Art. 896C.
Acceleration analysed at =0.82 m/s2 (measurement
uncertainty 0.19m/s2)
INSTALLATION
TRANSPORT
The EXPERT machine can be easily moved by using
the transport handles.
Before carrying the machine make sure that:
• the sliding carriage is secured by means of the
carriage locking;
• the motor head is completely lowered by
means of the locking lever;
5 • the legs are in transport position.
CAUTION
BEfORE MOVING THE LEGS, REMOVE THE
WORKING TABLE HANDLE.
3
To move the machine, use a four-arm tie rod
with the capacity to lift 200 kg or at least 20%
more than the machine weight, by making use
of the hooks in the transport handles.
HANDLING
By using the “transport wheels” accessory, the
machine can be moved with the aid of a second
person.
CAUTION
IN ORDER NOT TO COMPROMISE THE MACHINE
STABILITY, KEEP STRICTLY TO THE fOLLOWING
PROCEDURES.
WITH THE AID Of A SECOND PERSON, HOLD THE
MACHINE DURING THE WHEEL KIT INSTALLATION
OPERATIONS.
Starting from the working position, with the aid of a
second person:
a) hold the machine and loosen the left leg
locking pin (motor side);
4
b) lift the leg and put it in the wheel support;
c) lock the leg with the relative locking pin;
4
d) tighten the wheel support setscrew;
e) repeat the operation for the right wheel.
CAUTION
IN ORDER TO fACILITATE THE EXPERT MACHINE
MOVEMENT IN THE YARD, WE RECOMMEND
LOWERING IT UNTIL THE LOWERED POSITION.
a) loosen the leg locking pins on the front side
(working table side), one at a time, holding the
machine from the transport handles;
b) lower the machine front side, making the legs
slide inside the supports until the leg middle hole
matches the hole of the supports;
c) lock the legs by means of the relevant leg locking
pins;
d) repeat the operations indicated in points (a), (b),
(c) for the rear side (motor side).