Basta Boatlifts Solo 26, Руководство пользователя

Страница: 18 / 28

18
RIDGE RAIL ASSEMBLY
1. Slide two Rafter Clips into the dovetail slots of one of the ridge rails as shown in the drawing
above. Fasten them to the ridge rail with two nuts and bolts.
2. Line up the other ridge rail and slide it on to the Rafter Clips just installed. Fasten the assembly
together with two more nuts and bolts. There is no preferred direction for the bolts.
3. Install the Rafter Clips on the ends of the ridge rails as shown above. Note that the bolts are
installed in the two center holes of the clips.
RIDGE
RAFTER
CLIP
RIDGE
RAIL
RIDGE RAFTER
CLIPS (BOTH SIDES)
RIDGE
RAIL
RIDGE
RAIL
5/16 x 1 ¾"
hex head
SEE PAGE 17 FOR ADDITIONAL
INFORMATION ON
Solø™ 30, 33 and 39
CONSTRUCTION.
NOTE CHAMFER ON ALL
RIDGE RAFTER CLIPS
19
CORNER ASSEMBLY
1. Position one of the completed end rail
assemblies so that the free ends of its Splice
Plates can be inserted into the outer dovetail
slots of the assembled side rails.
2. Install a bolt through the end rail and Splice
Plate into the threaded portion of the Corner
Rafter Clip (shown at left - Bolt A). Be careful to
avoid cross threading - starting with a small gap
between the end and side rails will allow you to
see and more easily align the bolt to the Corner
Rafter Clip.
3. Insert a bolt in the unfilled bottom hole of the
Splice Plate through the side rail and Rafter
Clip (shown at left - Bolt B). Secure it with a nut
as shown at lower left. Note that the upper hole
is not used.
4. Repeat for the other three corners.
5. Position a corner rafter as shown at left. Its
grooved face should be facing up. Adjust the
side lacing rail position as necessary to allow
the rafter fixing bolt to be inserted. The bolt
should go through the hole in the Rafter Clip
and the hole at the end of the lacing rail. Install
the nut on the bolt finger tight.
6. The rafter may be swung down against the
side rail.
7. Repeat for the other three corner rafters.
END RAIL
SIDE RAIL
CORNER RAFTER
CORNER
SPLICE
PLATE
CORNER
RAFTER
CLIP
BUNGEE
CLIP
END
LACING
RAIL
BOLT
A
BOLT
B
5/16 x 2"
flat head
5/16 x 2"
flat head
5/16 x 3"
hex head
no bolt
RIDGE
RAFTER
CLIP
5/16 x 1 ¾"
hex head
LEAVE NUTS LOOSE
ON END CLIPS ONLY
RIDGE
RAFTER
CLIP
no bolts - clips “float”
NO BOLTS -THESE
CLIPS “FLOAT”
RIDGE
RAIL
RIDGE
RAIL
RIDGE
RAIL
Solø 26
Solø 30, 33, 39
STEP
6