Basta Boatlifts Solo 26, Руководство пользователя

Страница: 10 / 28

10
1. Install the 3/8 x 1” carriage bolts and nuts on
the outer legs and leave slightly loose.
2. Install the inner legs with the end with two holes
facing up. The carriage bolt heads slide in the slots.
3. Install 1/2 x 1 1/4" hex head set screws into the
nuts welded on the outer legs. Tighten until they
are flush with the inner
surface of the leg.
4. Orient the canopy legs with the slot in the inner
legs facing forward or aft.
5. Slide the canopy legs over the lift legs. The
bottoms of the canopy legs should rest directly on the
lift’s leg sockets. Tighten the 1/2 x 1 1/4 set screws.
LEG ASSEMBLY
INNER
LEG
OUTER
LEG
3/8 x 1"
carriage
C arriage bolts face forward or aft on
lift frame.
11
ATTACHMENT TO LIFT
6. Raise the canopy legs until their tops are level (horizontal) by loosening the carriage bolts
slightly one at a time and sliding the inner legs. A string, water or laser level will be very helpful
here. Recheck the legs for plumb and adjust as necessary.
7. Lash a pair of 2x4s tightly to the canopy legs with strong cord as shown below. They will make
the canopy installation much safer and easier.
8. Adjust the lift legs as necessary to assure that the canopy legs are plumb (vertical).
9. If the canopy includes six legs, the final pair is installed after the canopy frame is mounted.
1/2 x 1 1/4"
hex head set screws
1/2 x 1 1/4"
hex head set screws
TEMPORARY
WOOD SUPPORT
Two Holes
canopy leg
leg socket