MAINTENANCE
TM
DATE:
WHAT WAS DONE:
19
18
TROUBLESHOOTING PROBLEMS AND FAQ
IF THE PUMP DOESN’T RUN :
IF THE BATTERY WILL NOT HOLD A CHARGE:
1. Verify that the loaded boat is not exceeding the weight capacity of
the lift. If the battery is a flooded-cell type, check the electrolyte
level.
2. Ensure the solar panel is properly connected.
3. Re-align the solar panel for proper exposure to the sun.
4. Recharge the battery with a 10 amp charger and check the
charge again.
5. Have the battery tested. It may be old and require replacement.
6. If the lift is being used frequently during the day, it may be
necessary to use a 110-volt maintainer/charger.
IF THE REMOTE CONTROL IS NOT FUNCTIONING:
REMOTE CONTROL INFORMATION:
Q: DOES THE LIFT HAVE TO GO ALL THE WAY UP?
YES - in order for your lift to function as intended, the lift must
ALWAYS be stored in the full upright position when the boat is
unattended.
Q: IS MY BOAT SECURE?
Yes, once you verify that the lift is Over-Center , switch off the power
and lock the power unit box, there is less chance of theft.
™
Q: DO I NEED A MOORING LINE?
Under most circumstances one mooring line is sufficient to prevent
the boat from drifting away if the lift is inadvertently lowered or the
water level rises.
Q: HOW MUCH SUN DOES THE SOLAR PANEL NEED?
The panel should receive constant sun for at least 8 hours a day.
Q:
WHAT IF I GET A NEW BOAT?
Re-leveling the boat lift may be necessary. A new lift will be required
if the boat exceeds the weight capacity of your current lift.
IF THE PUMP RUNS, BUT THE LIFT DOESN’T MOVE:
1. Check the 'quick couplers' in the Power Unit.
If they are not
screwed together tight enough, the built-in check valves will not
allow fluid to flow.
See Page 13.
2. Check the fluid level. See Page 13.
Q: IS THE HYDRAULIC FLUID SAFE FOR FISH?
We use a special low-toxicity hydraulic fluid that is safe for the
environment. This mineral oil based fluid is different than food-grade
oil. Only use Basta Boatlifts approved fluid in your hydraulic system.
Q: HOW DO I CHANGE THE HYDRAULIC FLUID?
Our fluid should not require replacement for a considerable amount
of time. If yours has been contaminated or the hydraulic power unit
has been replaced, visit our web site at
www.gobasta.com
for
detailed instructions.
POWER-UP
At power-up the remote fob function has a ten second delay.
Failure to wait for this ten seconds can make the wait time
much longer.
LIFT OPERATION
The remote fob is non-functional until it is enabled by
depressing the lower right button momentarily.
After the
initial ten second delay, depressing the unlock button enables
operation using the remote fob.
The lockout is re-enabled
after 60 seconds without a button press.
Lift operation using the fob is limited to 120 seconds of
continuous operation. If a longer cycle is needed it is
necessary to release and then re-depress the button.
LOW BATTERY LOCKOUT
This control incorporates a low voltage lockout which is
intended to protect the battery from abuse and over-
discharge. When the battery drops below the low battery
threshold during pump operation, further activation using the
fob is not allowed. The battery needs to be checked prior to
further operation. The manual switches will allow the lift to
operate if sufficient battery power is present.
FOB PROGRAMMING
At initial power up there is a five second window when it is
possible to reprogram the receiver to enroll a remote fob. Up
to four fobs may be enrolled. If a fifth fob is enrolled, the first
enrolled fob will fall off the list.
To enroll a fob, turn off the power to the lift for fifteen or more
seconds. Turn power back on and press both the UP and
DOWN buttons on the fob simultaneously. This must be done
within the first five seconds after power is applied.
LIGHTING CIRCUIT
The lighting circuit is activated whenever the lift is operated.
The lights stay on for 2 minutes after the lift is operated and
may be manually operated by depressing the lower left button
on the remote Fob. When manually enabled the lights will
automatically turn off after 4 minutes. This is prevents
accidental battery discharge.
STORAGE
Always leave the boat in the fully raised, Over-Center™
position with the power off.
FOR ASSISTANCE OR SERVICE:
Contact your local dealer or call 1 - 866 - GO - BASTA
website: www.gobasta.com email: [email protected]
1. The battery in the key fob transmitter may be low. Replace it with a
new lithium CR2032. These are widely available at variety, hardware
and even grocery stores. Polarity is marked on the battery holder.
2. Verify that the power unit battery is charged and connections are
tight.
3. Reprogram the remote key fobs.
1. Check the battery charge and recharge if necessary.
2. Check the battery connections, clean and re-secure if necessary.
tm
Your Basta Boatlift requires very little maintenance once installed.
Occasionally wipe the solar panel with a clean, damp cloth to preserve its charging performance.
Every 6 months, we recommend:
Inspect the hoses, cylinders and fittings for leaks and wear.
Check the wire terminals for snugness and corrosion.
We
STRONGLY
recommend the use of a maintenence - free AGM type battery.
In a flooded cell type battery, the electrolyte should be slightly above the indicator ring in each cell.
Carefully add DISTILLED water if necessary. Do not over-fill.
Check the hydraulic fluid level.
The hydraulic fluid level should be about one inch below the top of the reservoir with the lift DOWN.
DO NOT add fluid with the lift in the raised position!
Use only Basta Boatlifts biodegradable non-toxic hydraulic fluid.
