GF Health Products, Inc. - www.grahamfield.com
Zenith Series Service Manual 999-0831-190C DEC. 2013
22
ZENITH SERIES
0DLQ)UDPH
+($'
(1'
OPTIONAL TRAPEZE SUPPORT INSTALLATION
(The Trapeze Support is attached to the head section of the bed.)
Please Order Kit Number ZA79000
Trapeze Support vertical
support tube. (TMI Bar
Sleeve would be inserted
inside the tube.)
Use first holes in
Trapeze Support
to mount to main
frame tubes.
USE SAME CLEVIS PINS AND HAIR PIN CLIPS
THAT WERE USED TO CONNECT HEADBOARD
TO MOUNTING TUBES.
Use third hole
from the end of the
main frame tubes.
1. Begin by removing the headboard panel assembly (#2),
if previously assembled to the bed, by pulling out the
two Clevis Pins and two Hair Pin Clips that attach the
main frame tubes to the headboard’s mounting tubes.
Set all pins aside for later use.
2. Detach the headboard panel from the mounting tubes
by unscrewing the four 40mm Allen Head Bolts that
hold the board to the tubes (these will be replaced with
the longer Phillips Head Pan Screws from the trapeze
adaptor hardware bag). Do not remove the (4) four
1/4-20 inserts (#3) from the board. They will be used
again to mount the board to the trapeze support.
3. Assemble the Trapeze Support (#1) to the main frame
tubes using the two Clevis Pins and Hair Pin Clips you
removed in Step 1.
The first holes in the Trapeze tubes
must line up with the third hole from the end in the
main frame tubes as shown.
4. Insert the 1/4-20 x 2.50” Carriage Bolt (#5) into the vertical
support as shown and fasten with a 1/4-20 Hex Head Lock
Nut (#6). Both parts should be in the hardware bag.
5. Assemble the headboard to the inside of the Trapeze Support
so that the side of the headboard with the inserts is facing
away from the Trapeze Support. From the outside, insert
the (4) four 1/4-20 x 1.75” long Machine Screws (#4) from
the hardware bag through the holes in the Trapeze Support,
screwing them into the inserts in the headboard.
6.
OPTIONAL - FOR TMI TRAPEZE BAR WITH SLEEVE:
Insert the Sleeve into the vertical support with the slot on
the bottom. Rotate the sleeve until it falls into place over
the carriage bolt you inserted in Step 4. This will lock it into
the proper position.
(NOTE: The top of the Sleeve should
sit flush with the top of the vertical support on the Trapeze
Support Adaptor.)
