12. Resetting to Factory Settings
Proceed as follows to reset the exterior unit to factory settings.
• Disconnect the exterior unit from the voltage supply.
• Remove the screws on the camera below and take these out
from the weatherproof frame.
• Keep pressing the tamper contact (7) on the back of the cam-
era and connect the exterior unit to the voltage supply again.
Wait for 30 seconds until the boot up is completed.
During the entire process, you must keep pressing the
release button, otherwise the alarm will be activated!
You also have the option to press the button with an
adhesive tape.
• Now press the recessed reset button (8) located on the back
for about 5 seconds.
• As soon as you hear a single sound, release the button.
• The exterior unit will restart (which takes about 30 seconds)
and the factory setting is restored.
• Disconnect the exterior unit from the voltage supply again and
release the release button (7).
• Put the camera in the weatherproof frame again and fix them
again with the screws.
42
