Basalte Auro Cresnet, Руководство пользователя

Страница: 6 / 13

Auro Cresnet
Manual
6 / 13 v1.0 © 2017 basalte
4. Changing the Basalte Auro Cresnet ID
A Basalte Auro Motion sensor ’s Cresnet ID is factory set to 25 .
To change the Cresnet ID, you can use the Network Device Tree View in Crestron Toolbox .
Right-click on a discovered Basalte Auro and press the Change Network ID ... button.
A new pop-up-window allows you to change the Cresnet ID.
To identify multiple Basalte Auro motion sensors, you can use the Identify This Device ... button
when right-clicking a Basalte Auro again. A new pop-up-window gives an overview of all Cresnet
devices in identification mode.
A request is then sent on the Cresnet bus to the selected Basalte Auro. The Polling Mode Status
says, ‘ Start requested, Start in progress ’.
After some seconds, this status will change to ‘ Active ’, and t he corresponding Auro ’s internal Led
will start flashing White. Now press the ‘ recessed button ’ on the back of the Auro. The Polling
Mode Status will change to ‘Pressed’. Pressing the OK button will bring you back to the Network
Device Tree View . Now you can change the Cresnet ID of the identified sensor.
Note: The recessed button is not accessible after physical installation. Make sure all auro devices
are properly identified before installation.