Basalte Auro Cresnet, Руководство пользователя

Страница: 10 / 13

Auro Cresnet
Manual
10 / 13 v1.0 © 2017 basalte
An overview of all available signals on the Basalte Auro motion sensor symbol:
Signal Name and Type Description
Digital input:
<
LED >
The Auro’s internal Led can be controlled by this digital input.
When the ‘ Led Mode ’ is set to ‘Follow Motion’, this digital input
will be overruled by the motion feedback.
The ‘Led Mode’ is set using the ‘ Basalte Auro Configuration ’
module.
High/1 = Led On; Low/0 = Led Off
Digital output:
<
Motion >
This output will be pulsed High as long as there is any motion
detected.
High/1 (pulse) = Motion detected
Analog output:
<
Lux_Sensor_FB >
Reports the ambient light in the room using Auro’s internal
light sensor.
Depending on the report type, the lux value will be updated
cyclically or at a certain change in value.
The report type can be set
using the ‘ Basalte Auro
Configuration ’ module.
Valid values range from 0 to 4500, depending on the set
parameters.
Analog output:
<
Temperature_FB >
Reports the temperature measured by Auro’s internal sensor,
in tenths of a degree Celsius or Fahrenheit.
Depending of the report type, the temperature will be updated
every 60 seconds, or on every temperature change of 0.5°
Celsius. (equal to 0.9° Fahrenheit)
The temperature format and report type can be set using the
‘ Basalte Auro Configuration ’ module.
Serial input:
<
Configuration$ >
Needs to be connected to the serial output
<
Initialize_To_Device$ > on the ‘ Basalte Auro Configuration ’
module.
Serial output:
<
Status$ >
After a power cycle of the Auro, this string reports the sensor ’s
software version.
If an invalid string is received on the <
Configuration$ >
input, an error message will be displayed on this output.
Serial output:
<
Temperature_FB$ >
Reports the ambient room temperature in following format
“xx.x”.
Depending of the report type, the temperature will be updated
every 60 seconds, or on every temperature change of 0.5°
Celsius. (equal to 0.9° Fahrenheit)
The temperature report type can be set using the
‘ Basalte
Auro Configuration ’ m odule.