- 39 -
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device
(see rating plate).
Connect the device only in case of compliance!
The power supply circuit with the socket must be protected by the fuse of at least 16A.
Connect the device directly to a single grounded socket. Do not use any power bar or
multiple socket.
5.2 Operation
5.2.1
Preparation of the device
The device should be thoroughly cleaned before the first use. Follow
instructions in
section 6 “Cleaning and maintenance”
.
Fill the device with water before use, paying
attention to the “MIN” mark on the basin back wall.
When the water level is below the “MIN” mark,
the sensors installed below detect it and the
device does not start. The digital display shows
error code E001.
Always fill the device with water above
the “MIN” mark.
Connect the device to the single grounded socket.
Start the device by pressing
ON/OFF
key (1). (fig on page 40).
The “click” sound is heard. The digital display shows the current water temperature
in the basin.
