Bartscher Q25, Инструкция по эксплуатации

Страница: 16 / 52

E
n
g
li
sh
16
71503928/0 - rEV.00 01/2013
f ) EVAPORATOR ASSEMBLY REPLACEMENT
• remove the top cover.
• remove six screws securing the paddle shaft supports (two)
and the paddle motor support; then remove the paddle
motor/paddle shaft/supports assembly.
• remove the bolts securing the evaporator supports (two) to
the cabinet.
• Sideways remove the evaporator supports.
• Unsolder the capillary tube, the hot gas solenoid valve tube
and the suction line.
• To install the replacement evaporator assembly follow pre-
vious steps in reverse.
• Install the replacement drier; thoroughly evacuate the sys-
tem and proceed with the refrigerant charge.
g) WATER RESERVOIR/TILTING LEVER/SUPPORT ASSEMBLY
REPLACEMENT
• remove screws and top cover.
• remove the gear motor/paddle shaft/support assembly.
• remove the screws securing the evaporator supports (two).
• Sideways remove one evaporator support support as well as
one reservoir gudgeon support.
• Slightly lift the evaporator and remove the water reservoir
assembly.
• To install the replacement water reservoir assembly follow
previous steps in reserve.
h) WATER INLET ELECTROVALVE REPLACEMENT
• remove the rear panel.
• Check that water supply is closed.
• Disconnect the water supply connection pipe from the valve
and that of the electrovalve from the reservoir.
• Break contact from the electrovalve and remove the screws
(two) securing the electrovalve to the relevant frame.
• To install the replacement electrovalve follow previous steps
in reverse; before installing the water supply pipe check that
the gasket is not defective.
i) PADDLE MOTOR REPLACEMENT
• remove the top cover.
• remove six screws securing the paddle shaft supports (two)
and the paddle motor support.
• Trace the electric wire leads of paddle motor and disconnect
the same; then remove the paddle shaft motor assy.
• remove the paddle shaft assy from the paddle motor gud-
geon (or guide pin).
• To install the replacement paddle motor follow previous
steps in reverse.
l) HARVEST MOTOR REPLACEMENT
• remove the top cover.
• remove the screws securing the harvest motor to the cabi-
net base.
• remove the seeger from the cam pin.
• Trace the electric wire leads of harvest motor and disconnect
the same; then remove the harvest motor/cam/support as-
sembly.
• remove the lock pin securing the cam to the motor shaft
and the screws joining the harvest notor to the relative sup-
port.
• Install the replacement harvest motor on the support and
apply the cam; make a Ø 3 mm hole on the motor shaft and
to do it take as a guide the hole already existing on the cam.
• To install the replacement harvest motor assy follow previ-
ous steps in reverse.