- 25 -
•
Make marks at the desired height for drilling with the fastening plate held up against
the wall. Drill holes and place wall plugs
10
inside. Use the supplied screws
11
to
mount the fastening plate
9
to the wall.
•
Place the dryer on the fastening plate
9
so that it is securely on the hooks of the
fastening plate
9
.
•
Before mounting the device on the fastening plate, run the power cord through the
openings at the rear of the device and secure it in them.
•
Turn the fastening screws
13
and attach the fastening screw caps
12
.
•
Place the device so that the plug is easily accessible so as to quickly disconnect
the device if the need arises.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device (see
rating plate). Connect the device only in case of compliance!
Connect the device only to properly installed single socket
with protective terminal.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
5.2 Operation
•
Plug the device into a suitable socket.
•
Turn the device on using the ON/OFF switch.
•
The digital display will show the operating mode, „0“ time counter and a diagram
showing how to place hands inside the device.
•
The red LED lighting in the air shaft will come on.
