- 27 -
5.3 Operating
ATTENTION!
The operation of the device may only be carried out by personnel that have been
instructed in operation of the device and the special hazards of frying.
•
Delicately place the switching unit on the rear edge of the oil reservoir until a click
sounds. Both pivots at the bottom of the switching unit must be in the openings on
the oil reservoir. Only then is the switching unit properly set up. For safety reasons,
the unit functions only when the switching unit is properly secured to the casing, and
in this manner a microswitch indicates to the unit that it may function.
•
Ensure that the device is switched off (Temperature control toggle is in position “0“).
•
There may be no oil at all in the oil container before filling it with oil. The oil container
must be clean and dry.
•
The oil drainage valve must be closed and blocked off (handle facing down).
•
Carefully fill the oil container with oil up to the required level (between „MIN“- and
„MAX“- marking in the container). Markings are at the side of the oil reservoir.
ATTENTION!
Do not use the device without having frying oil in the oil container. Make sure the
oil level is always between „MIN“- and „MAX“- marking of the oil container.
Temperature control
ON/OFF
switch
Power control
lamp (green)
Heating control
lamp (orange)
Switching unit with
heating element
Switching unit with
heating element