- 29 -
Keep checking the water level throughout the process. If the water pump cannot
inject water, the ice cube maker stops automatically, the sound signal is sent out
and the indicator
„Add water“
lights up. Press the
„Stop“
button
to
switch the device off.
Pour fresh drinking water into the container to just below the mark.
Press the
„Start“
button
to contine the ice cube making process.
Once the ice cube basket is full, the ice cube maker stops automatically.
The sound signal is sent out and the red indicator
„The ice cube basket is full“
lights up. Empty the ice cube basket.
Press the
„Stop“
button
and later on the
„Start“
button
to continue the
ice cube making process.
CAUTION!
If the compressor has stopped for whatever the reason, e.g. no water, too many
ice cubes in the ice cube basket etc., wait for ca. three minutes for the cooling
agent to settle in the compressor before restarting the device.
If you are not going to use the device anymore, switch it off.
Press the
„Stop“
button
.
NOTE!
For reasons of hygiene, if you are not using the device for longer
than 24 hours, drain the water from the water container.
To remove water from the water tank,
place a container under the drainage
pipe at the bottom of the nit. Remove
the ice cube tray.
Open the drainage pipe by removing
the stopper at the bottom of the water
tank (see photo at right).
After the water tank is empty, replace
the stopper.
If after a longer stoppage you are going to use the device once again, pour fresh
water into the container, carry out 2 - 3 ice cube making cycles and remove the
produced ice cubes.
Stopper
Drainage pipe
