- 25 -
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that
of the device (see type label). Connect the device only in case of compliance!
Take note of the security advice!
5.2 Installation and connection
•
Unpack the device and discard and remove all of the packing material.
•
Place the device on top of an even and safe surface which supports the weight of the
device.
•
Choose a surface where the ice cube maker is not exposed to direct sunlight, or close
to a direct source of heat such as a cooker, oven or radiator.
•
Make sure that there is at least 15 cm distance between the back and the sides of the
device and the wall.
•
Let the cooling agent settle for an hour. Only then plug in the device.
•
If the ice cube maker is kept outside during the winter and then taken inside for use,
please let it warm up to room temperature before plugging it in.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed from
its socket in case of necessity.
5.3 Operating
•
Before use, the device should be cleaned (see
6.2 Cleaning).
•
Connect the device to an appropriate, single outlet.
•
Carry out the ice cubes production cycle as described below.
CAUTION!
Ice cubes obtained in the first production cycle should not be used for cooling
beverages or food products for hygienic reasons, but this ice should be
disregarded.
•
Select the size of the ice cubes by pressing the
"select button"
on the control panel.
If the temperature in the room exceeds 16° C is rec ommended to select the size
"
S - Small" or "M - Medium" in order to
prevent the ice cubes from sticking
together.
www.food-service.com.ua
