Bartscher AT90-DIG, Руководство пользователя, Страница: 18 / 22

Installation and operation
16 / 22 A120799
EN
Temperature Unit (°C / °F) Change
The temperature may be set in Fahrenheit and Celsius degrees. By factory default,
the set temperature unit is “°C”.
The set temperature unit may be changed in the following way:
– Switch the appliance on with the ON/OFF switch.
– Press and hold the SET function button until
“000”
is displayed on the
digital thermal processing time display.
– With the use of settings value increase or decrease buttons alter the
indication to
“008”
.
– Press the SET function button.
– With the use of settings value increase or decrease buttons select 00 or
01 (00 = °C, 01 = °F).
– Press the Timer start button and complete the setting with Start/Stop
button.
The set temperature unit is indicated by the relevant indicator light lit.
Food Preparation
NOTE!
Prior to each use, heat the convection oven properly. Set the temperature
approx. 30°C above the required temperature and correct it when food is
put into the oven in order to obtain uniform effect.
As soon as the set temperature is reached, the heating-up indicator light goes off.
When the temperature in the oven chamber drops (e.g. when the glass pane door is
open, food is put in the oven, etc.), the appliance heats up again and the heating
indicator light lights up anew.
1. Insert suitable sheets with food on them onto convection oven guide rails.
At a time, 4 baking sheets on 4 guide rails of the convection oven may be inserted.
2. During packing of the appliance, make sure that there is a top clearance of at
least 40 mm between dishes and baking sheets, which will allow for maintaining
optimum heat distribution in the baking chamber.
3. If needed, set the thermal processing time and temperature again.
4. Activate timer (if thermal processing time settings were altered) by pressing the
Timer start button.
The remaining thermal processing time will be shown on the digital thermal
processing time display.
After expiry of the set thermal processing time, “END” message will be shown on a
respective digital display and audible signal will be generated for 6 seconds.