GENERAL
INFORMATION
1
Safety devices
Microswitch:
stops the machine
when the grater lever is lifted. When
the lever is lowered, restart the
machine by pressing the
I
button.
Remote control switch:
can be used
to restart the machine when the
electricity supply is switched off
accidentally.
For
Grater mod.GR12/S
only, when
the machine stops, the electronic board
intervenes to block the roller using the
motor brake.
Safety information
•
It is of the greatest importance to carefully read this manual before carrying out installation and use
operations. Consistent compliance with the instructions contained in this manual will guarantee personal
and machine safety.
•
Do not tamper with the safety devices for any reason.
•
We recommend that industrial safety regulations issued nationally by the appointed organisms be strictly
respected.
•
The manufacturer declines all responsability for injures to persons or damages to property, resulting from
failure to comply with these safety rules.
•
Correct machine setting, lighting and workshop cleanness are pre-conditions for personal safety.
•
Do not expose the machine to atmospheric agents.
•
The machine connection and start-up should only be executed by skilled engineers.
•
Check that the plant mains ratings correspond to the specifications printed on the machine data plate.
•
Make sure that the machine is connected to a grounding system.
•
The work area around the machine should always be kept clean and dry.
•
Wear the work attire prescribed by the industrial accident-prevention regulations.
•
This machine should always be used for its recommended uses ; any other use is deemed improper and
therefore dangerous.
•
Check the suitability and weight of the products to work ; do not overload the machine to exceed its
capacity.
•
It is forbidden to introduce any objects, tools or hands in the dangerous parts.
•
Keep the machine out of children’ s reach.
•
Unplug the machine from the mains when not in use.
•
In the event of breakdowns and/or malfunctioning, do not carry out any repair yourselves, apply to your
Authorised dealer.
•
Order original spare parts only.
•
Before carrying out machine cleaning, unplug it from the power mains.
•
Do not clean with high-pressure water jets.
DANGER – CAUTION: Using plates with hole diameters over 8mm
and with total thickness under 5 mm is strictly prohibited.
Should wear cause plate thickness to drop under 5 mm, we recommend
you replace it. The manufacturer is not liable for any personal or property
damages due to failure to observe these instructions.
7
