Installation Instructions
20 / 32
1583011
EN
7. Re-fit the sealing washer and screw back on the pressure connection
(A).
8. Re-fit the control panel back on the appliance.
9. Fix gas controllers.
Switching to Different Gas Type
• Switching to a different type of gas, e.g. from natural gas to liquid gas, is done
through exchange of nozzles of the main burner, bypass burner and pilot burner.
All nozzles are marked with one digit (diameter in 1/100) and delivered in one
bag.
• After each switching or adaptation remember to perform operation check and
change the additional label according to the performed make-over or adaptation.
Replacement of Main Burner Nozzles
1. Remove all gas controllers.
2. Remove the control panel from the appliance through screwing out bottom
fastening screws in order to have access to nozzle handles.
3. Undo fastening screw of a nozzle handle.
4. Replace the existing nozzle to a nozzle that is suitable to a given gas type (see
MAX data for nozzles in Table 2
'Characteristics of Burners and Nozzles'
).
5. Screw the nozzle on.
6. Convert all gas burners one by one, following instructions provided above.
Exchange of Small Adjustment Nozzle
1. Undo small by-pass adjustment nozzle (MIN, Fig. 2).
2. Exchange this nozzle to a nozzle that is suitable for the new type of gas. These
data (MIN) should be sourced from Table 2
'Characteristics of Burners and
Nozzles'
.
Replacement of Pilot Burner Nozzle
1. Use a flat screwdriver to undo the pilot burner nozzle.
2. Replace the existing nozzle to a nozzle that is suitable to a given gas type (see
data for nozzles in Table 2
'Characteristics of Burners and Nozzles').
3. Re-fit the control panel on the appliance.
4. Re-fit all gas controller on the appliance.
ATTENTION!
After switching to a different type of gas look for possible leakages, using
suitable spray or suds (never use open fire!).
Содержание 1583011
Страница 1: ...Flex 7360 1583011 ...
